I have no idea how long a full scan would take, but usually the scan is for only those codes already programmed into the remote, which probably aren’t a whole lot so it shouldn’t take too long. The instructions and codes for the BD-512 are now in the Files Section (thanks again, Daniel). You would know if the remote kept the setting by the fact that the TV operates when you press a button. I have to assume (not always a good thing) that the remote will continue to send the power command until the TV set turned off (if it was on), and at that time you would press any key to exit, which would remember the code. The most common code for a GE Satellite is 11864. The red light will blink twice again to confirm that you’ve entered the code correctly. hold set key & press power for more than 3 seconds To program your GE Cable box with this code: Press and hold the SETUP button on your remote until the red light blinks twice.
Try it both ways if you are unsure which way is better.ġ. When you perform step 5, I don’t know if you need to point the remote towards the set and hold the power button down and release it when the TV turns off, or if you can just repeatedly press the power button, and then if the TV turns off press any other button. hold down power button & point towards set. press set again & release to start search modeĥ. Since I have never seen this remote or the instructions before, these are only my interpretation of the instructions.ģ.
